Articles
Short articles on duct sizing, with worked examples and links to the calculators. Estimates only.
How to calculate duct static pressure: the TESP test, step by step
Where to put the test ports on a furnace, air handler or package unit, how to add the supply and return readings, a worked example that finds the restriction, and what high and low readings point to.
Rectangular duct CFM chart: how much air each size carries
What a 12 x 8, 20 x 8 or 24 x 12 sheet metal duct carries at 0.08 and 0.10, why flat ducts carry less, and how to check an old trunk before you quote a bigger system.
Manual J vs Manual D: what each one sizes, and how they connect
Manual J gives you the loads, Manual S picks the equipment, and Manual D designs the ducts. What goes in and comes out of each, a worked handoff from room loads to duct sizes, and what the code says.
How to use a ductulator (slide rule or online)
Set the friction rate, line up the CFM, then read the size and the velocity. A worked 800 CFM example, the rectangular side, and the readings that end up undersizing a duct.
Flex duct CFM chart: how much air 6 to 16 inch flex carries
An 8 inch flex run carries a lot less than an 8 inch metal one. The chart for 6 to 16 inch flex, what sag and compression cost you, and a worked bedroom run.
CFM chart for round duct: how much air each size carries
Start from the duct you can see, not the CFM you want. What a 6 or 16 inch round carries, and how to check existing ductwork before you quote a bigger system.
How to round a duct sizing chart result to a real size
The chart says 10.2 inches. Nobody sells 10.2. What happens to friction and speed when you go up to 12 or down to 10.
Looking for a number? Start with the duct size calculator or the duct size chart.